Pressure reducer
|
||
|
Adjusting the reducer
1. All reducers have a factory setting for an output pressure of 3.0 bar.
2. The reducer can be adjusted without dismantling it.
3. Before adjusting the reducer installed in the system, it is recommended to open the maximum possible number of water valves to remove air from the pipeline.
4. Adjustment is made by turning the knob. Clockwise rotation increases the value of the adjustment pressure. Counterclockwise rotation decreases the pressure. The value of the set pressure is displayed on the side scale. The graduation is provided for information only, use a pressure gauge for checking (pressure gauge is not included).
5. Adjustment of the reducer is made at a flow rate close to zero, but not zero. This means that all water valves in the system must be closed, and the minimum possible jet flow rate is left on one of the devices (the flow rate at which the stream coming out of the spout does not split into separate drops).
Body material: | Brass CW617N |
Operating pressure, pn: | from 1 to 5.5 bar |
Operating environment temperature, ° C: | from 5 to 80 |
Thread of connecting nozzles: | 1/2"-3/4" |